Vision VPD370WD User Manual download pdf (Page 13)

4. Installation

■ Preparing the Camera and Decorative Cover for Side Cable Exit

The camera and decorative cover should be prepared as shown below when mounting the camera on a ceiling or wall

with its cables(power, video output, RS485, alarm in Relay out) exiting from the side.

The camera mounting base needs to be removed in order to prepare the camera.

See step 1 and 2 below for information about how to remove the camera mounting base.

* Prevent the dome cover from being scratched by placing it on a soft cloth while you are working.

Preparing the Decorative Cover

■ Installing the Camera for Indoor

* Select an installation location that is strong enough to withstand the total weight of the camera.

Installing the camera at a location that is too week can cause it to fall.

* If you are using an optional bracket to install the camera, install the bracket in accordance with the instructions that

come with it

1. Remove the fixing screw(M3x6) that secures the camera to the mounting base and put the screw in a place where it

will not become lost.

Step 1

Cut it off with a razor knife

Fixing screw

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 42 43

No comments

Vision VPD370WD User Manual Page 13