52 VE810 Engraver Manual
(Figure 5.14) External Fuses
Fuse and voltage
“select” cartridge
Locking tab
Step 2
Step 3
Fuse holder
Replacing the Internal Fuse
If the internal fuse ever blows, you will need to change it. Follow the procedure below to
change the internal fuse.
1. Unplug the power cable that goes into the back of the VE-810.
2. Use a 3/32 of an inch Allen wrench and remove the 4 screws on the back of the VE-
810. See figure 5.15.
(Figure 5.15) Removing the Electronics Tray
Screws
3. Use a 3/32 of an inch Allen wrench and remove the two screws underneath the VE-810
towards the front of the machine.
4. Slide the electronics tray out the backside of the VE-810. See figure 5.16.
Comments to this Manuals