Vision VE-810 User Manual download pdf (Page 47)

Chapter 5 - Maintenance 47

Changing the Motor Brushes

The motor brushes on the engraving motor should be inspected regularly, and replaced

when worn. The motor brushes are worn when the length of the brush is less than 1/8 of

an inch.

Inspect the brushes for possible replacement annually using the following procedure.

Press the X Jog key to move the spindle to the middle of the table.

CAUTION: Disconnect the power cable going into the back of the VE-810 before

continuing!

Use a 3/32“ Allen wrench and remove the two cover screws shown in figure 5.7.

(Figure 5.7) Cover Screws

Allen Screw

Use a 3/32” Allen wrench to remove the 4 back cover screws shown in figure 5.8.

(Figure 5.8) Back Cover Screws

Back Allen Screws

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 61 62

No comments

Vision VE-810 User Manual Page 47