Vision 2448 User Manual download pdf (Page 7)

Page7

Assembling the

optional table stand.

Approximate time for

assembly is 10-20

minutes.

Chapter 1

Description 24x24 Qty 24x48 Qty

1. frame 38" w/o holes 4 -

2. frame 62" w/ holes - 2

3. frame 62" w/o holes - 2

4. frame 19.5" w/ holes 2 2

5. frame 19.5" w/o holes 2 3

6. frame 25" w/o holes 4 4

7. locking swivel caster 4 4

8. mounting bracket

(optional) --

9. t-handle hex key 1 1

10. socket head cap screw (5/16-18 x 1 1/4”) 16 16

11. sae (AN 5/16”) flat washer 16 16 !

12. socket head cap screw (1/4-20 x 4 1/2”) 4 4 "

13. nylock 4 4 "

14. uss (1/4”) flat washer 8 8 "

15. Instruction Sheet 1 1

!connects frames together "mounts table (not shown) to frame

(one extra for center cross beam)

A. Cross beam is only for the 24” x 48” table stand.

B. Swivel casters are inserted up into the frame, in the positions indicated.

The ring at the neck of the caster can be turned to tighten the caster in place, once inserted.

C. Four 4¼” bolts are used to connect the table to the roll-around frame.

Note: All connections are made with a socket hex screw and washer (supplied).

Do not fully tighten all screws until the engraving table is bolted to the cross members (#4’s);

then align the legs (#6’s) to corners of the engraving table. This helps the overall alignment.

(used to bolt center cross beam)

1.or2.

1.or3.

(Figure 1.3)

Table stand for Vision 2424 and 2448 models

Step 7.

1 2 3 4 5 6 7 8 9 10 11 12 ... 43 44

No comments

Vision 2448 User Manual Page 7