Vision 2448 User Manual download pdf (Page 36)

Page36

Chapter 7

Riser Block Extensions

The optional riser block kit allows you to raise the entire gantry assembly quickly and simply. Each

end of the gantry assembly is supported by two tower blocks stacked on top of each other. Riser

blocks are installed between the two tower blocks, and add height to the gantry.

Riser Block Installation (See Fig 7.13)

Determine the extra height required, and select riser blocks of appropriate height. One end of

the gantry has long threaded rods topped by washers and nuts. Loosen the nuts on the

threaded rods. On the other end of the gantry, loosen the bolts. Raise the gantry for clearance,

and slide a riser in between the two tower blocks on each end of the gantry. For higher exten-

sions use the longer bolts and additional riser extensions as needed. Always add the same

height to each end of the gantry. When finished installing the riser blocks, be sure

to retighten all bolts and threaded rods.

(Figure 7.13) Riser Blocks Installation

nut

washer

threaded

rod

riser

right side

gantry

support

blown up area

NOTE: With Series 3 Vision Table models, the

gantry cover cannot be replaced after the risers

have been installed.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 42 43 44

No comments

Vision 2448 User Manual Page 36