Vision 2448 User Manual download pdf (Page 30)

Page30

Chapter 6

SPINDLE PRESSURE ADJUSTMENT FOR SERIES2 VISION TABLES

The pressure of the spindle nosecone against the material can be

controlled by adjusting the down pressure in the Z-axis assembly. If

the cutter is skipping across the material or engraving unevenly, the

pressure should be increased. Locate the black knurled thumb wheel

below the Z-axis motor (see “1.” in fig 6.10). To increase the

pressure, turn the thumb wheel clockwise. The pressure can be

decreased by rotating the thumb wheel counterclockwise.

For deep engraving into metals: the Z-axis may be

locked so that no float exists. Simply rotate the thumb

wheel fully clockwise until it bottoms out.

(Figure 6.10) Close up of the Series2

carriage assembly

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 43 44

No comments

Vision 2448 User Manual Page 30