Vision 2448 User Manual download pdf (Page 38)

Page38

Chapter 7

(Figure 7.15) Vacuum Chip

Removal System

The Vacuum Chip Removal System

The optional vacuum chip removal system is designed to simplify the engraving process and

minimize wear and tear on the engraver. The vacuum chip removal system uses a vacuum nose

cone to remove chips created during the engraving process before they have the chance to create

problems. The quiet pump, coupled with the microfine-layered filters assures that your unwanted

chips are whisked away effortlessly. The vacuum pump canister uses replaceable filters that can

also be reused, to assure maximum efficiency and cost-effectiveness.

The vacuum chip removal system allows prompt removal of chips and dust created in the engraving

process, reducing contamination and overheating in the spindle area. Chip removal also prevents

the cutter from skipping over letters due to stray particles. This vacuum chip removal system is

available with or without a Vision vacuum nose cone.

Vacuum Pump System

Elbow pipe connector

Vacuum filter canister

Vac hose connector

(large end)

Vac hose

(2" clear)

Vac hose

(threaded)

Vac nose - black

Vac hose connector

(small end)

ALL PIECES CONNECTED

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 44

No comments

Vision 2448 User Manual Page 38