Vision 2448 User Manual download pdf (Page 13)

Page 13

Connection of Power, Cables, and Controllers

Additional boxes may have been shipped along with your table, depending on the system ordered.

These will typically include a control unit and associated cables. The proper connection of these

cables is essential. Check the appropriate user’s manuals for your controller before attempting to

connect them it to the table. After connection of the cables as directed by your controller manual,

power can be connected to the system. It is suggested that a surge protector be used.

An “Auxiliary” Power Strip may have been included with your purchase. This strip is used for

automatically starting and stopping accessories via the Vision Series 3 controller’s “AUX ON/

OFF” button. Typical uses include: Vacuum Systems, Air-Assist units, oiler, lighting, 3.25 HP

Router motor (Porter cable Only) etc. Please DO NOT plug any of your Vision equipment (except

the vacuum system) into this strip, as it will not function unless the Vision Series 3 controller is

powered on. This is not possible with the “Auxiliary” strip, because it is always OFF unless the

controller is powered on and “AUX ON/OFF” is green.

Chapter 2

Chapter 2:

Setting Up The Table

(Figure 2.1) Breakout box with 25-pin connection to the Vision Series 3 controller

Back view of the

Vision Series 3

controller

Breakout box

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 39 40

No comments

Vision 2448 User Manual Page 13