Vision TM-UST Owner's Manual download pdf (Page 5)

ENGLISH

INSTALLATION INSTRUCTIONS

1. Attach the wall plate to the wall using six appropriate xtures. When you have attached

the wall plate you will have 170mm of height adjustment, but it is still important to position

it carefully. In rooms with low ceilings the height you can mount the screen/whiteboard will

be limited by the ceiling height so the bracket should be mounted as close to the ceiling as

possible. Where you have plenty of ceiling height, you should mount the screen/whiteboard

in place rst to determine where the TM-UST should be positioned.

Most interactive whiteboards have side-to-side adjustment when in place, and the TM-UST

has ample up/down adjustment. Read the projector’s manual for advice.

For the Hitachi CP-A range of ultra short throw projectors the wall plate should be 100mm

to the right of the centre of the whiteboard/screen as you look at the wall. The chart below

gives approximate guidelines for the distance between the bottom of the wall plate and the

top of the viewable screen surface for common screen and whiteboard sizes.

For the Sanyo PLC-XE50 ultra short throw projector the wall plate should be 80mm to the

left of the centre of the whiteboard/screen as you look at the wall. The chart below gives

approximate guidelines for the distance between the bottom of the wall plate and the top of

the viewable screen surface for common screen and whiteboard sizes.

Screen Diagonal Screen Width Bracket Distance

(inches) (mm) (mm)

57 1158 170

64 1300 190

77 1565 240

82 1666 290

94 1910 300

98 1991 320

Screen Diagonal Screen Width Bracket Distance

(inches) (mm) (mm)

77 1565 260

80 1626 270

82 1666 280

94 1910 320

98 1991 340

1. Wall

2. Wall plate

3. Rawl plugs

4. ST8 Bolts

1 2 3 4 5 6 7 8 9 10 ... 57 58

No comments

Vision TM-UST Owner's Manual Page 5