Vision Cylindrical Instruction Manual download pdf (Page 15)

•TROUBLESHOOTING

Trouble Condition Possible Cause Corrective Measure

System will not move to limits •Is the power cord connected? •Connect the power cord securely.

•Is the power strip/source on? •Turn on the main power strip.

•Use the software feature Run: Move to Limits

to test your limits.

Pump does not turn on / has •Check to see that enough liquid is in •Use 1 Gallon of water to 1 Teaspoon of oil —

very limited flow the basin of the engraver. fill to the line..

•Check to see if debris is clogging the •Make sure the vents to the pump motor are

pump. clear.

Engraves on one axis only •Is the power cord connected? •Connect the power cord securely.

•Are any external objects blocking the •Move the handle of the mug or anything else

travel of the moving parts in the interfering with the engraver’s mechanics.

machine.

Uneven or ragged characters on •Are all cables connected? •Secure all cable connections.

the finished piece •Are any external objects blocking •Move the handle of the mug or anything else

the movement of the mechanics? interfering with the engraver’s mechanics.

•Is the diamond graver tip damaged •Replace the diamond graver tip.

or worn?

•Engraving too fast. •Try slowing down the X-Y movement.

•Depth settings are incorrect. •Reduce depth to eliminate chip out.

•Mug or glass object may not be •Adjust the item in the tail and head stock.

secure in the tail and head stock.

The glass chips or breaks on the •Is the diamond graver tip damaged •Replace the diamond graver tip.

finished piece or worn?

•Recirculating pump is not on. •Turn the recirculating pump on.

•Mug or glass object may not be •Adjust the item in the tail and head stock.

secure in the tail and head stock.

•Engraving too deep or too much •Reduce engraving depth or tool pressure.

tool pressure.

•Some glass has imperfections that •Attempt the same job with another piece of

may weaken it. glass.

Main switch light or front panel •Is the power cord connected? •Connect the power cord.

LED indicators will not •Is the power strip/source on? •Turn on the main power strip.

illuminate •Check the main power fuses.

CHAPTER 4 Troubleshooting & Maintenance

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 21

No comments

Vision Cylindrical Instruction Manual Page 15